Basically there are two groups of people that have a problem with their Bluetooth communications. One group is called “knock-knots” and the other group is called “knock-knocks”. The reason this term is used is because they both work similar with the same requirements to complete a task.
Knocked-knocked radios are radio devices that have a diode in between two conductors that is on the radio transceiver or transmitter. This results in a short that prevents energy from passing through and delays the start of the transmission.
If this process of knock-knocking is interrupted for any reason, it will result in the radio signal becoming effectively lost. If a signal is not delivered during a radio transmission then it can be considered as a “loss” and should be replaced by a new one, even if it was perfectly fine previously.
The main problem in many cases is that the signal has to be broken by the user using the equipment or it becomes garbled. Sometimes this is accomplished by stopping the transmission and resetting the transmitter or by changing the channel from active to inactive. However, other times the signal has to be re-established before it becomes clear again.
These systems are designed to provide a signal by taking advantage of a short circuit to occur, then by triggering the antenna in a manner that makes it respond to the situation. If you are having problems with interference in Bluetooth voice transmission you need to be able to tell if you are experiencing interference.
Try to look at the way the antennas were set up. Many times you will be able to follow the signal that has been interrupted by looking at the antennas and the cable that is connected to the radios.
Often these antennas and cables are either too close together or too far apart. This may result in it blocking the signal entirely from reaching the radio transmitters. In this case it is more likely that you have a failure in the connection rather than a problem with the radio itself.
In this case you will have to take the time to test the signal and make sure that it is working correctly before you have to call a technician. However, sometimes you may not be able to access the problem by looking at the cables alone.
Some applications use matlab as a means of communication between the application and the radio. In most cases the equipment and application work together perfectly and all you have to do is get the communication to work.
However, if there is a problem in the communication line between the radio and the application then you should know about it. To test the communication between the application and the matlab, you should make sure that the radio is being able to receive a message.
You will have to try sending and receiving some commands to the radio and verify that the message is being received. If the message is not being received then there is a problem that you will have to solve immediately before the problem is resolved.