In this case, it would be a good idea to look at your project again. Is there any MATLAB code you wrote that creates a waveform? Did you figure out how to make it so you can generate the waveform?
It’s actually fairly simple to do this. Just open the project in MATLAB and look for the waveformData object. You’ll see there are different kinds of waveforms. Each has an associated command, you can run that will give you an output.
There are WaveformData, WaveformData3D, WaveformDataWave, WaveformTransform, and WaveformDataZoom. Each kind of waveform has its own set of commands that can be run. If you’re working with WaveformData, you can run the command “generateTriangle.” This will produce triangle waves.
If you want the frequency of a waveform to change, you can run the command “generateTriangleWave.” This will produce a triangular wave at the current frequency.
If you want to produce an impulse response for a waveform, you can run the command “generateTriangleImpulse.” This will produce an impulse response at the current frequency. In this case, you might want to increase the frequency of the wave.
If you want to have a waveform beep at the current time, you can run the command “generateSquareBubble.” This will produce a square bubble and then stop. If you run the command at a different time, you’ll get a different result.
Now that you know about WaveformData, WaveformDataWave, WaveformDataWave3D, WaveformDataWave, WaveformTransform, and WaveformDataZoom, it’s time to look at what you can do with them. If you want to create a frequency response with one of the waveforms, you can run the command “generateTriangleFreq.”
The same thing applies if you want to have a color response with WaveformData, WaveformDataWave, WaveformDataWave3D, WaveformDataWave, WaveformDataZoom, or WaveformTransform. Here’s what to do:
Now that you know about WaveformData, WaveformDataWave, WaveformDataWaveWave, WaveformDataZoom, WaveformTransform, and WaveformDataZoom, it’s time to look at what you can do with them. If you want to create a frequency response with one of the waveforms, you can run the command “generateTriangleFreq.” This will produce a triangular wave at the current frequency. If you run the command at a different time, you’ll get a different result.
If you want to have a color response with WaveformData, WaveformDataWave, WaveformDataWaveWave, WaveformDataZoom, WaveformTransform, or WaveformDataZoom, you can run the command “generateSquareBubble.” This will produce a square bubble and then stop.
If you want to have a frequency response with WaveformData, WaveformDataWave, WaveformDataWaveWave, WaveformDataZoom, WaveformTransform, or WaveformDataZoom, you can run the command “generateTriangleFreq.” This will produce a triangular wave at the current frequency.